Eight Precautions for Daily Troubleshooting of Organic Fertilizer Equipment

 Organic fertilizer equipment is simple and practical, and the fertilizer produced can be quickly absorbed by crops. In order to better use the organic fertilizer production equipment, it is very important to maintain the organic fertilizer equipment. Below we will focus on the maintenance of the organic fertilizer production equipment.

1. The shaft in the organic fertilizer production equipment bears the full load of the negative machine, so good lubrication has a great relationship with the bearing life.

2. Lubricating oil directly affects the service life and operation rate of the organic fertilizer equipment, so the injected lubricating oil must be clean and the seal must be good. The main oil injection point of the machine is the rotating bearing, the roller bearing, all the gear movable bearings, and the sliding plane.

3. The newly installed wheel tyres are prone to loosening and must be checked frequently.

4. For organic fertilizer equipment, attention should be paid to whether all parts of the machine are working properly.

5. Pay attention to check the degree of wear of the easily worn parts of the organic fertilizer equipment, and pay attention to replace the worn parts at any time.

6. The bottom frame of the movable device of the organic fertilizer equipment should be cleaned of dust and other debris to prevent the movable bearing from moving on the bottom frame when the machine encounters unbreakable materials, which may cause serious accidents.

7. If the rotating gear in the organic fertilizer equipment is running, if there is an impact sound, stop it immediately for inspection and eliminate it.

8. The problem of unsatisfactory drying effect in organic fertilizer drying equipment. If the organic fertilizer dryer equipment can meet the output, the drying effect is not good. It is mostly due to the unreasonable internal structure or the insufficient length of the cylinder. Although these are not major problems, the degree of impact on the interests of users is very high. The method is to rationally adjust the internal lifting plate and the length of the lifting plate according to the material requirements to diffuse the material and increase the contact area with the hot air. The increase of the simplified length extends the drying time.